Star-water-systems S1585 Manuel d'utilisateur télécharger pdf (Page 4)

BATTERY

RED LEAD

TO POSITIVE(+)

TO NEGATIVE(-)

BLACK LEAD

SWITCH

CUT AWAY OF SUMP PIT

RED LEAD

TO POSITIVE(+)

MOTOR

CHARGER

NEGATIVE(-)

BATTERY TERMINAL

POSITIVE(+)

OUTLET

ALARM

BLACK LEAD

TO NEGATIVE (-)

PRIMARY PUMP

DISCHARGE

MAIN

CHECK VALVE

LINE

PRIMARY PUMP

CHECK VALVE

DISCHARGE

LINE

MAIN

STEP 4 Electrical Connections

4.1) Complete electrical connections as shown in Fig ure 4.1.

4.2) Proceed to STEP 6.

Do not place battery or charger directly on ground. If the

battery or charger must be placed directly on the ground, then place

a piece of wood between the units and the ground. Do not put the

charger on top of the battery.

Figure 4.1

STEP 5 Testing of Pump Operation

6.1) Unplug the primary pump so that it does not start.

6.2) Fill pit with water until the Aquanot® starts.

6.3) Verify that the pump starts and stops at the desired on/off points.

6.4) Verify that there are no leaks in the discharge line.

6.5) If adjustment is necessary, raise or lower the appropriate stop(s) according to STEP 2.

IMPORTANT: Spacing between upper and lower stops determine amount of water removed from pit.

6.6) If the pump is not operating properly after following the above steps, refer to the Troubleshooting guide on page 8.

6.7) When ﬁ nished testing plug primary pump back into AC receptacle.

STEP 3 Installation of the Discharge Piping

3.1) Assemble the discharge pipe into the pump as shown in

Figure 3.1.

IMPORTANT: In order for this installation to work properly, a check

valve must be installed onto the discharge line.

( Recommend the following Star check valve, #KH34.

Some local codes require union check with ball valve.

Figure 3.1

SK1783

SK1778

1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire

Star-water-systems S1585 Manuel d'utilisateur Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Pompes Star-water-systems S1585